Wall-Mounted Nameplate Plaque

Here are practical CAD measurements for a wall-mounted, 3D-printable version of “The Barnhill Family” farmhouse name plate. Overall Sign Width: 280 mm Height: 180 mm Total thickness: 8 mm Base plaque thickness: 4 mm Raised border height: 2 mm Raised lettering/decor height: 2 mm Maximum finished thickness: 8 mm This size fits many medium-format printers diagonally. For a Bambu Lab P1S, X1C, or A1, scale it down to approximately 245 mm wide. Plaque Shape Main rectangular area: 240 mm × 150 mm Top center arch height: 18 mm Bottom center curve depth: 12 mm Side decorative extensions: 20 mm each side Outer corner radius: 18 mm Inner corner radius: 12 mm Border Outer border width: 5 mm Inner decorative border width: 2.5 mm Gap between borders: 3 mm Border extrusion above plaque: 2 mm Minimum border thickness at narrow points: 2.5 mm Lettering “The” Approximate width: 48 mm Height: 31 mm Letter thickness: 2.2–3 mm minimum Raised height: 2 mm Position: centered, approximately 18 mm below the top edge “Barnhill” Approximate width: 215 mm Capital letter height: 61 mm Lowercase height: 45–48 mm Minimum stroke thickness: 3 mm Raised height: 2 mm Position: centered vertically around 80 mm from the bottom “Family” Approximate width: 100 mm Height: 34 mm Minimum script stroke thickness: 2.5 mm Raised height: 2 mm Position: centered below “Barnhill” Gap below “Barnhill”: 5 mm Decorative Lines Line thickness: 2.5 mm Line height: 2 mm Upper lines: approximately 48 mm long Lower lines: approximately 50 mm long End dots: 5 mm diameter Keep at least 4 mm between lines and lettering Barn Decoration Width: 40 mm Height: 34 mm Main wall thickness: 2.5 mm Door-line thickness: 1.5–2 mm Raised height: 1.5–2 mm Position: centered approximately 18 mm above the bottom border Leaf Branches Each branch: Length: 92 mm Main stem thickness: 3 mm Leaf length: 14–18 mm Leaf width: 6–8 mm Leaf thickness: 2 mm Raised height: 2 mm Minimum gap between leaves: 2 mm Hanging Holes For wall mounting: Hole diameter: 5 mm Hole center distance: 210 mm Hole center from top edge: 12 mm Optional keyhole slot: Large opening: 8 mm Narrow slot: 4 mm Slot depth: 2.5 mm Recommended Print Settings Layer height: 0.20 mm Walls: 3–4 Top/bottom layers: 5 Infill: 10–15% Material: PLA or PLA Matte Print orientation: flat on the back Supports: not required Add a 0.4 mm chamfer around the plaque’s bottom edge to reduce elephant foot For easier multicolor printing in Bambu Studio, make the plaque, border, words, barn, and leaves separate bodies while keeping them inside one 3MF project.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.