Two-Zone Reservoir Body (115x26 / 140x120)

Modify the existing reservoir while preserving its general geometry. Keep: - overall height 150 mm; - lower chamber height 100 mm; - wall thickness 5 mm; - two horizontal slots 103 mm wide × 3.8 mm high; - slot center-to-center vertical spacing 16 mm; - current slot vertical positions; - 12 mm diameter bottom drain hole; - no rollers or internal mechanisms. Change the lower chamber: - Increase outer depth from 24 mm to 26 mm. - Keep outer width 115 mm. - This creates an internal lower chamber approximately 105 mm wide × 16 mm deep. - The 150 mL operating liquid volume must remain entirely below the transition to the dry upper zone. Change the upper section: - Increase upper outer size to 140 mm wide × 120 mm deep. - With 5 mm walls, create a large top opening approximately 130 mm × 110 mm. - Keep a flat perimeter rim for a future removable lid. - Smoothly taper from the lower chamber to the larger upper section between Z=100 mm and Z=150 mm. Keep both belt slots entirely above the liquid chamber and centered horizontally on the same interface face. Do not create rollers, shafts, bearings, belt, motor, brackets, lid, valve or scraper. Generate one hollow solid reservoir body only.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.