Toyota Dyna Tail Light Sheet Metal Enclosure

Design a SHEET METAL PART (not a solid block), representing a folded metal enclosure with an angled wedge profile, made from a single flat blank bent via straight fold lines. Material: constant 1.5mm wall thickness throughout (true sheet metal shell, not solid extrusion). CRITICAL REFERENCE: front face lens opening must fit a real Toyota Dyna tail light lens measuring 330mm wide x 216mm tall. Cutout window: 335mm wide x 220mm tall (small clearance for mounting), centered on the front angled face. Overall outer dimensions (folded, 3D): - Width: 350mm (330mm lens + ~10mm frame margin each side) - Depth: 250-260mm (enough to house socket, wiring, switch mechanism behind the lens) - Height: 230-240mm (216mm lens + ~10-12mm frame top/bottom) Front face: angled/slanted panel tilted backward at approximately 20-25 degrees, matching the wedge profile seen in reference photos, with the 330x216mm lens cutout centered. Top panel: slopes gently from the tallest point at the back down toward the front lens frame, following the angled wedge shape. Bottom panel: flat rectangle, 350mm x 260mm. Back panel: flat rectangle, 350mm wide x matching the tallest back height. Bend lines: straight fold lines matching the angled profile, 2mm inside bend radius, 5mm relief cuts at bend line ends. Switch mounting holes: on the top panel near the back-right corner, 3 through-holes, 8mm diameter, diagonal staggered line, ~20mm spacing. Add 4 through-holes, 6mm diameter, in the bottom panel corners, 8mm inset from each edge. Output requirement: model must unfold into a single flat pattern with defined bend lines and constant wall thickness, suitable for laser cutting and press brake bending — NOT a solid machined part.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.