Subaru GD Cup Holder Adapter Cradle

Create a parametric, single-body drop-in adapter cradle to mount an aftermarket round cup holder into a 2002–2004 Subaru Impreza GD center console cup holder pocket: 1. Units and Coordinates: - Units: Millimeters (mm). - Origin (0,0,0): Centered horizontally at the top mating plane (Z = 0). - Z-axis: Vertical axis (+Z upward into cabin, -Z downward into cavity). - X-axis: Longitudinal axis (negative X is front, positive X is rear). - Y-axis: Lateral axis (transverse width). 2. Top Perimeter Flange (Bezel Lip): - Base plane at Z = 0, extrude upward along +Z to Z = 2.5 mm. - Profile: A 73.0 mm long (X) by 73.0 mm wide (Y) shape centered around X = 0. - The two front corners (at -X) have 5.0 mm fillet radii. - The rear edge (at +X) is a continuous semi-circle with radius R = 36.5 mm. 3. Tapered Insert Plug Body: - Create a solid loft extending downward 50.0 mm along the -Z axis (from Z = 0 to Z = -50.0 mm). - Top Sketch (at Z = 0): 67.5 mm long (X) by 67.5 mm wide (Y) centered on the same axis; front corners have 5.0 mm fillets, rear is a semi-circle with radius R = 33.75 mm. - Bottom Sketch (at Z = -50.0 mm): 58.0 mm long (X) by 58.0 mm wide (Y); front corners have 4.0 mm fillets, rear is a semi-circle with radius R = 29.0 mm. - Loft between the top sketch and bottom sketch into a solid body, and union seamlessly with the top flange lip. 4. Internal Gimbal Receiver Bore: - On the top surface (Z = +2.5 mm), cut a centered vertical cylindrical blind hole. - Diameter: 68.6 mm. - Depth: Cut downward along the -Z axis by 42.0 mm (from Z = +2.5 mm down to Z = -39.5 mm), leaving a solid ~13.0 mm floor at the base. - Clean and deburr all sharp internal and external edges.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.