SSD Enclosure Assembly

Title: 2-Piece Enclosure for Nollie RGB Controller with SSD 2.5" Mounting Part 1: The Base (Chassis) Main Body: Create a rectangular block with outer dimensions of 130mm (Length) x 70mm (Width) x 14mm (Height). Inner Cavity: Subtract a rectangular pocket in the center of the top face. The pocket dimensions must be 119.2mm (Length) x 36.5mm (Width) x 11.2mm (Depth). Cable Routing (Cutouts): On the two short ends of the inner cavity (the 36.5mm sides), remove the wall material completely to the top edge to allow cables to exit. Add two small vertical separator posts in the middle of these cutouts, spaced exactly 3.1mm apart from each other. Bottom Mounting Holes (SSD Standard): On the bottom face of the main body, create 4 blind holes (diameter 3mm, depth 3mm) for M3 screws. Arrange these holes in a perfect rectangle measuring exactly 76.6mm by 61.72mm, centered on the bottom face. Lid Mounting Posts: In the four outer corners of the main body's top face, add 4 threaded holes (diameter 2.5mm for M3 self-tapping screws) to secure the lid. Part 2: The Lid (Cable Clamp) Main Body: Create a flat rectangular plate measuring 130mm (Length) x 70mm (Width) x 3mm (Thickness). Mounting Holes: Create 4 through-holes (diameter 3.2mm) in the corners, aligning perfectly with the lid mounting posts of Part 1. Clamping Lips (Strain Relief): On the two short ends of the bottom face of the lid, extrude a downward lip that is 36.5mm wide (matching the base cavity) and drops down by 8.7mm. When assembled, this lip must leave exactly a 2.5mm vertical gap between the lip and the floor of the base cavity, acting as a compression clamp for the rubber cables. General Parameters: Fillet all outer vertical edges of both parts with a 2mm radius for a smooth finish. Keep inside corners of the cavity perfectly sharp (0mm fillet) to accommodate the rectangular device.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.