Gears and transmission
Spur Gear with Hub
- Bounding box
- 10.5 × 10.5 × 12.0 mm
- Engine
- Precision B-rep
- Parameters
- 7
- Published
- September 29, 2026
Download
Free to download and use. See the terms.
The prompt
From your measurements, I would initially model the gear with: 12 teeth Module: 0.75 mm Pitch diameter: 9.00 mm Outside diameter: 10.50 mm Root diameter: 7.85 mm Bore: Ø5.00 mm Toothed face width: 7.53 mm Hub extension: 4.47 mm Overall axial length: 12.00 mm Hub outside diameter: Ø9.00 mm Pin holes: 2 × Ø2.25 mm Pin holes: 180° apart Pin-hole axial position: approximately 0.40 mm below the end of the toothed section
Parameters
| Name | Value | Range |
|---|---|---|
| Module | 0.75 mm | 0.3 – 3 |
| Number of Teeth | 12 count | 5 – 80 |
| Pressure Angle | 20 deg | 14.5 – 25 |
| Toothed Face Width | 7.53 mm | 2 – 20 |
| Bore Diameter | 5 mm | 3 – 8 |
| Hub Extension | 4.47 mm | 1 – 20 |
| Hub Outside Diameter | 9 mm | 6 – 12 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Spur Gearbox
design gearbox
Involute Spur Gear with Keyway
Precision Involute Spur Gear with Hub and Keyway: Module (m) of 2.0 mm, 40 teeth (z), Pitch Circle Diameter (d) of 80.00 mm, 20° pressure angle (\alpha), 15.00 mm face width (b), a
Parametric Helical Gear
Create a parametric helical gear with the following specifications: 32 teeth, normal module of 3 mm, right-hand helix, total face width of 80 mm, and a central bore hole with a dia
Rod with Spur Gear
Metal rod diameter is 20 mm and length is 100 mm and right side attach a gear and their OD is 50 mm
Spur Gear (12 Teeth)
Built a gear with 12 teeth
Two-Stage Spur Gear Reduction Assembly
Design a 2-stage spur gear reduction set for 3D printing with an overall 10:1 ratio. Stage 1: A 12-tooth pinion driving a 36-tooth gear (3:1). Stage 2: A 12-tooth pinion coupled