Sheet-Metal Control Cabinet (Assembled)

Create one CAD solid named cabinet_shell. Units: mm. Global coordinates: origin at the front-bottom-left outer corner of the closed cabinet, +X right, +Y up, +Z toward the rear. Model the part in place; do not recenter. Light-gray open-front rectangular sheet-metal enclosure body, uniform 1.5 mm walls (left, right, top, bottom, rear), no door. Sharp 90 degree outer corners, no fillets. Outer extents X 0-400, Y 0-500, Z 3.5-200 (the door and a 2 mm gasket occupy Z 0-3.5). Interior clear: X 1.5-398.5, Y 1.5-498.5, Z 3.5-198.5. Cutouts through the walls: - Top panel: four Ø5.5 holes at (X,Z) = (135,88), (135,112), (265,88), (265,112). - Left wall (X 0-1.5): louver opening 80 x 22 mm at Y 336-358, Z 50-130, filled with 5 horizontal louver slots (3 mm high, 4.4 mm pitch), blades sloped 35 degrees downward toward the outside; plus one Ø12 round hole centered at Y 372, Z 130. - Right wall (X 398.5-400): the same louver at Y 336-358, Z 50-130, no round hole. No other holes. No door, hinges, or fasteners. Create six labeled CAD bodies. Units: mm. Global coordinates: origin at the front-bottom-left outer corner of the closed cabinet, +X right, +Y up, +Z toward the rear. Model in place; do not recenter. 1) front_door: flat light-gray 1.5 mm plate, X 0-400, Y 0-500, Z 0-1.5, sharp corners. Cutouts: - LCD window 224 x 127 mm, R2 corners, centered at (X 140, Y 406). - Camera hole Ø10 centered at (295, 406). - Fan grille: circular opening Ø38 centered at (358, 406), filled with 7 horizontal slots (2 mm high, 4.5 mm pitch) clipped to the circle; four Ø3.4 holes at (342,390), (374,390), (342,422), (374,422). - Lock hole Ø22 centered at (310, 240). 2) door_gasket: 2 mm thick x 5 mm wide rectangular perimeter bead on the inner face (Z 1.5-3.5), outer edge inset 0.5 mm from the plate edge. 3) hinge_1: concealed-hinge placeholder block, X 3-15, Y 80-130, Z 1.5-11.5. 4) hinge_2: same block at Y 370-420. Door pivot axis is vertical at X 2, Z 1.5. 5) swing_handle_outer: swing handle on the outside face, X 289-331, Y 180-300, Z -20 to 0, edges R4. 6) lock_inner_body: placeholder for the lock body behind the door, X 295-325, Y 215-265, Z 1.5-35.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.