3D preview of Servo Door Switch Mounting Base
Loading the interactive model…
Interactive 3D model of Servo Door Switch Mounting Base

Brackets and mounts

Servo Door Switch Mounting Base

1 views
Bounding box
120 × 70 × 42 mm
Engine
3D Printing B-rep
Parameters
20
Published
November 22, 2026

Download

Free to download and use. See the terms.

The prompt

A robust 3D printable mounting base for an automatic door switch mechanism. Base: A thick rectangular base plate (120mm x 70mm, 6mm thick, flat bottom). Servo Bracket (Feature 1): At one end of the base, there is a vertical U-shaped support structure to hold a Tower Pro SG90 9g micro servo. The servo is mounted vertically (upright), with two side walls having M2 screw holes to secure it. The servo arm points downward. Reinforcement (Feature 2): Add thick triangular ribs (gussets) connecting the back of the vertical servo bracket to the flat base plate to prevent snapping during downward pressure. Height: The servo bracket must be tall enough (at least 25mm) so the downward-pointing servo arm can fully press an 8mm protruding switch without the base hitting it. Electronics Tray (Feature 3): At the opposite end of the base plate, a shallow rectangular recessed tray (60mm x 28mm, 3mm walls) for an ESP32 board. Keep it blocky and solid for FDM printing."

Parameters

NameValueRange
Overall length120 mm100 – 200
Overall width70 mm50 – 140
Plate thickness6 mm4 – 12
Corner mounting hole dia4.5 mm3 – 6
Bracket wall thickness3 mm2 – 6
Wall height above base top36 mm25 – 60
SG90 body width12.2 mm8 – 20
SG90 body length22.5 mm15 – 30
Pocket clearance per side0.4 mm0.1 – 1
Servo face height above base top16 mm8 – 30
Servo support ledge width3 mm1.5 – 5
Servo support ledge thickness2.5 mm1 – 5
M2 clearance hole dia2.4 mm1.8 – 3.4
Gusset reach along base14 mm8 – 30
Gusset height24 mm10 – 40
Gusset thickness4 mm2 – 8
Tray inner length60 mm30 – 70
Tray inner width28 mm15 – 45
Tray wall thickness3 mm1.5 – 6
Tray recess depth2.5 mm0.6 – 5

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.