Rover Body Assembly

Design a small, compact, lightweight 3D-printable medicine-delivery rover body according to these exact requirements. IMPORTANT: Do not add any extra compartments, tiers, caster wheels, locks, screens, or mechanisms that are not specified. OVERALL TARGET Approximate footprint: 270 mm × 190 mm (27 × 19 cm) Keep the rover as small and compact as possible. Total 3D-print filament for all printed rover parts: UNDER 500 g Total print time: 8–9 hours maximum Use thin walls, hollow sections, and reinforcement ribs only where needed. Avoid unnecessary material. EXACT STRUCTURE The rover has exactly THREE sections: TOP — Medicine Box MIDDLE — Power Bank Compartment BOTTOM — Motor Base Final arrangement: MEDICINE BOX ↓ POWER BANK COMPARTMENT ↓ MOTOR BASE There is NO separate electronics compartment. 1. TOP — MEDICINE BOX Create a fully enclosed medicine-storage compartment at the top. Requirements: Medicine box must be the highest section. Enough internal space for medicines. Simple lightweight hinged door. Door must open and close manually. No lock. No electronic lock. No motorized locking mechanism. Include internal wire-routing space. Include wire-holder slots/clips. Include aligned wiring holes through the bottom. Include the required plug/socket connection points for attaching to the power-bank compartment. 2. MIDDLE — POWER BANK COMPARTMENT Create ONE enclosed compartment directly below the medicine box. Requirements: Power bank must fit completely INSIDE. Include a lightweight retaining system for the power bank. Leave cable clearance. Include internal wire-routing space. Include wire-holder slots/clips. Include aligned wiring holes between this compartment and the motor base. Include coordinated plug/socket connections to both the medicine box and motor base.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.