Robot Mounting Plate 200x120x15

Keep the current plate size at 200 mm × 120 mm × 15 mm. Keep the four robot mounting holes centered with 53 mm spacing in X and 53 mm spacing in Y. Keep the two 11 mm M10 clamp holes at the left and right sides. For the four robot mounting holes, make them 4.5 mm through holes for M4 bolts. Add a counterbore on the bottom side of each hole so the M4 screw head can sit fully recessed and the bottom surface of the plate remains flat on the table. Use an 8 mm counterbore diameter and 4 mm depth. The robot arm will be raised using four separate 6 mm metal standoffs, so do not add any raised platform to the plate. For the two M10 clamp holes, add a 17 mm diameter counterbore, 6 mm deep, on the top side so the M10 bolt head can sit recessed. Keep the 11 mm through hole. Remove any decorative grooves, arcs, center marks, or unnecessary geometry from the plate. Keep the plate flat, symmetric, and mechanically simple with rounded corners.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.