Reservoir with Flat Interface Wall

Modify the existing reservoir to match an external wooden cover. Keep: - overall size: 140 mm wide × 120 mm deep × 150 mm high; - wall thickness: 5 mm; - large top opening approximately 130 × 110 mm; - perfectly flat and vertical interface wall; - bottom drain hole: 12 mm diameter; - no rollers or mechanisms. Change the lower liquid chamber: - outer width: 115 mm; - outer depth: 50 mm; - liquid chamber height: 50 mm; - keep it against the flat interface wall; - taper the opposite and lateral walls upward into the larger upper body. Belt slots on the flat interface wall: - exactly two horizontal through-slots; - each 103 mm wide × 3.8 mm high; - lower slot center at Z = 56 mm; - upper slot center at Z = 72 mm; - vertical center-to-center distance: 16 mm; - horizontally centered. The geometry must keep approximately 150 mL of operating liquid below Z = 45 mm, leaving dry clearance below the lower belt slot. The flat interface wall must remain completely planar so it can sit flush against the wooden cover. Assembly reference: - reservoir top must align with the top of a 104 mm high wooden cover; - therefore the reservoir extends 46 mm below the bottom of the wooden cover; - with this alignment, reservoir slot centers Z=56 and Z=72 correspond to cover slot centers Z=10 and Z=26. Do not create rollers, shafts, bearings, belt, motor, brackets, lid, valve or scraper. Generate one hollow solid reservoir body only.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.