Parametric Wall-Mounted Dish Rack

Create a simple parametric wall-mounted dish rack. Overall width: 400 mm. Depth: 250 mm. Create one horizontal dish-holding tier for 10 plates. Use 10 evenly spaced plate slots with 35 mm center spacing. Plates must stand nearly vertical, tilted 12 degrees toward the wall. Use two longitudinal support rails under the plates and simple separator fins between plate positions. Create a rear wall-mounting frame with two vertical side supports. Add four 6 mm mounting holes. Add two triangular braces between the rack and the rear frame. Structural thickness: 5 mm. No legs. No countertop support. No water tray. No decorative details. Make width, depth, plate spacing, plate angle, thickness and hole diameter parametric.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.