Parametric L-Bracket with Holes and Chamfers

Modify the existing L-bracket model. DO NOT change the existing L-shaped body. Add the following features exactly: 1. Vertical leg: 80 mm high × 60 mm wide × 8 mm thick. Create 2 circular THROUGH HOLES, each Ø10 mm. The holes must pass completely through the vertical plate. Place both holes on the vertical centerline of the 60 mm width. Their centers must be 40 mm apart vertically, with the hole centers located 20 mm from the top and bottom edges. 2. Horizontal leg: 80 mm long × 60 mm wide × 8 mm thick. Create 2 circular THROUGH HOLES, each Ø10 mm. The holes must pass completely through the horizontal plate. Place both holes on the width centerline of the 60 mm width. Their centers must be 40 mm apart along the 80 mm length, with the hole centers located 20 mm from the front and rear edges. 3. Root fillet: Apply an R5 mm internal fillet along the complete inside 90° junction between the vertical and horizontal legs. 4. Edge chamfers: Apply 1 mm × 45° chamfers to the required outer edges. 5. Final geometry: Maintain a 90° included angle between the two legs. 6. Material: Aluminium 6061-T6. Important: The final model MUST contain exactly 4 Ø10 mm through holes: 2 on the vertical face and 2 on the horizontal face. Do not omit the holes. Do not create blind holes. Do not alter the overall dimensions.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.