Mitutoyo Digimatic 10-pin Connector Plug Housing

Coordinate system: Origin (0,0,0) at the bottom-front-left corner of the housing. X-axis = width (10 mm), Y-axis = height/thickness (4 mm), Z-axis = length, front-to-back (15 mm). "Model a solid, watertight, manifold rectangular prism housing with overall bounding-box dimensions of 10mm (X-axis, width) x 4mm (Y-axis, height) x 15mm (Z-axis, length), with the origin (0,0,0) at the bottom-front-left corner. The front face (Z=0 plane) must remain fully solid and closed, with no penetrations, holes, or slots — it is a flat, sealed end cap. On the bottom face (Y=0 plane), cut 10 parallel open longitudinal grooves (blind slots, U-shaped or rectangular cross-section, open at the bottom, not through-holes) running along the Z-axis from the front face (Z=0) toward the rear face (Z=15mm), stopping approximately 1mm short of the rear face to preserve solid wall thickness at the back. Each groove should be approximately 0.5mm wide and 0.5mm deep, centered along the X-axis at a pitch (center-to-center spacing) of 1.6mm between adjacent grooves, symmetrically arrayed so the full set of 10 grooves is centered within the 10mm width. At the rear face (Z=15mm plane), add a single cylindrical bore of 4mm diameter, coaxial with the Z-axis, centered on the X-Y cross-section (X=5mm, Y=2mm), drilled inward from the rear face to serve as a cable strain-relief/exit hole, intersecting with the rear ends of the longitudinal grooves to form the internal pin-routing channel. The final geometry must be a single watertight manifold solid suitable for FDM/resin 3D printing, with no self-intersecting or non-manifold edges, and all boolean subtractions (grooves and bore) cleanly resolved against the base rectangular prism."

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.