Main Enclosure Base

Text-to-CAD Prompt: Main Enclosure Base Create a 94.0 x 69.0 x 40.0 mm solid rectangular box. Shell it open from the top face with a uniform 2.0 mm wall thickness. Top Rim: Cut a 1.5 mm deep by 2.0 mm wide continuous recessed groove around the top perimeter edge. Corner Bosses: In the four interior corners, extrude cylindrical bosses (7.0 mm OD, 3.4 mm ID hole). Extrude them from the floor so they are completely flush with the top rim. Partition: Extrude a 2.0 mm thick partition wall across the center of the X-axis, splitting the Y-axis into two 31.5 mm chambers. Make this wall exactly 18.0 mm high from the floor. Cut two 6.0 mm circular holes through it. Bottom Chamber: Extrude two parallel 50.0 x 2.0 x 4.0 mm guide rails on the floor, spaced 28.5 mm apart inside. Cut a 13.0 x 8.0 mm USB hole in the adjacent right exterior wall. Top Chamber: On the left floor, extrude four 5.0 mm high standoffs (4.0 mm OD). Cut 5 vertical louver slots in the left wall. On the right interior wall, extrude two vertical rails protruding 3.0 mm inward. Cut 5 vertical slots in the adjacent right wall. Exterior Mounts: Cut two 3.75 x 1.25 mm horizontal grooves across the exterior bottom. Extrude four external mounting tabs (10.0 mm outward, 12.0 mm wide, 2.0 mm thick) completely flush with the bottom floor. Place two on the left wall, two on the right, inset 15.0 mm from the corners. Cut a 4.5 mm hole through each tab.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.