Magnetic Clip Assembly

Create a two-piece magnetic clip assembly for hanging string lights from the inside screen wall of a camping tent. Model the two pieces as separate printable solid bodies positioned next to each other, not joined. Use millimeters for all dimensions. INSIDE LIGHT-HOLDER BODY: Create a rounded capsule-shaped base measuring 32 mm long, 14 mm wide, and 3.2 mm thick. Round all exterior edges with a 1.5 mm fillet to prevent damage to the tent screen. The flat back surface will contact the inside of the tent screen. Add two circular magnet pockets opening from the flat screen-facing surface. Each pocket must be 6.2 mm in diameter and 1.9 mm deep to accept a 6 mm diameter by 1.78 mm thick round magnet with adhesive. Position the magnet centers along the length of the body, 18 mm apart, centered across its width. Maintain at least 1.2 mm of material behind each magnet pocket. On the opposite, room-facing surface, add an integrated C-shaped snap clip for a 4 mm diameter string-light cord. Orient the cord channel parallel to the 32 mm length of the base. Make the internal channel 4.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.