LUMA Motion Waistband Clip V1

LUMA MOTION — WAISTBAND CLIP V1 Create ONLY the LUMA Motion WAISTBAND CLIP and its matching two pouch rails. This is a real mechanical prototype, not a decorative model. CLIP: 60 mm wide × 45 mm tall × 6.5 mm thick. Rounded corners, sleek, compact, low-profile and premium-looking. FRONT OF CLIP: Create TWO identical vertical FEMALE DOVETAIL CHANNELS, side-by-side and evenly spaced. Each channel is recessed into the clip and OPEN at the TOP. The channels run vertically downward and end at a solid bottom stop. The channels must have a TRUE DOVETAIL/UNDERCUT PROFILE: the inside of each channel is wider than its opening. This creates a mechanical lip that captures the matching rail. POUCH RAILS: Create TWO separate vertical MALE DOVETAIL RAILS that match the channels exactly. Each rail is approximately 35 mm long, maximum 7 mm wide and approximately 4 mm proud from the pouch surface. Each rail has a narrow neck and wider dovetail head. The rails slide DOWN from the TOP of the clip and become mechanically captured inside the female channels. CRITICAL: The rail heads must physically sit BEHIND the channel lips when inserted. The pouch cannot simply pull straight away from the clip. The pouch can only be removed by sliding UP after the future safety catch is released. FIT: Use approximately 0.20 mm sliding clearance per mating side. Make this clearance editable. BOTTOM STOP: Both channels must have a physical bottom stop so the pouch reaches one definite seated position. APPEARANCE: Make the clip smooth, rounded and sleek, not bulky. No giant rails. No large rectangular holes. No L-shaped bracket. No single center slot. No decorative grooves pretending to be channels. SHOW: 1. Clip alone. 2. Two rails alone. 3. Rails entering the top of the clip. 4. Both rails fully seated inside the channels. 5. A side/cutaway view clearly showing the dovetail heads captured behind the channel lips. The assembled view must clearly prove that the two male rails physically fit INSIDE the two female dovetail channels. Do not add the safety catch, button or magnets yet. Those will be added after this core rail system is correct.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.