LUMA Motion Clip V1 - Dovetail Channels + Inserted Rails

CORRECT THE CURRENT MODEL — DO NOT REDESIGN IT. The two slots are currently simple rectangular notches. Replace them with TWO TRUE VERTICAL DOVETAIL CHANNELS. Each channel must have a narrow opening at the front but a wider internal cavity behind it, creating a mechanical undercut. Create TWO matching MALE DOVETAIL RAILS with a narrow neck and wider head that fits inside the wider cavity. The rails must slide DOWNWARD into the channels from the TOP. The wider rail head must be mechanically captured behind the channel walls so the rail cannot pull straight away from the clip. Keep: 60mm clip width 45mm clip height 6.5mm clip thickness 35mm rail length ~7mm maximum rail width ~4mm rail projection 0.20mm sliding clearance Add a solid bottom stop at the bottom of both channels. MOST IMPORTANT: Show one assembled view with BOTH male dovetail rails FULLY INSERTED into BOTH female dovetail channels. The rails must visibly be inside the channels, not sitting beside the clip. Do not make rectangular slots. Do not make an L-bracket. Do not make one large slot. Do not change the overall clip size.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.