LUMA Motion Clip V1

Create LUMA Motion Clip V1 as a simple parametric 3D-printable CAD assembly. CLIP BODY: 60 mm wide 45 mm tall 6.5 mm thick Rounded outer corners. ATTACHMENT: Create TWO identical vertical FEMALE DOVETAIL SLOTS in the front face of the clip. The slots are parallel and open at the TOP. They must run downward and end at a solid bottom stop. Create TWO separate matching MALE DOVETAIL RAILS. Each rail: 35 mm long 7 mm maximum wide 4 mm projection Rails are vertical and parallel. The two male rails must slide DOWN into the two female slots and become mechanically captured inside them. Use 0.20 mm sliding clearance and make it adjustable. IMPORTANT: Show the rails actually inserted inside the slots in an assembled view. The slots must be recessed channels, not lines or decorative grooves. Do NOT create an L-shaped bracket. Do NOT create one large slot. Do NOT make the clip larger than 60 × 45 × 6.5 mm. Create these separate parts: 1. Clip body 2. Left rail 3. Right rail Make all geometry solid, manifold and suitable for FDM 3D printing.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.