Lower Scanner Base Housing

Create a parametric lower structural base housing for a rugged handheld 3D scanner. Overall exterior dimensions: - Width, left to right: 284 mm - Depth, front to back: 95 mm - Height: 128 mm - Wall thickness: 4 mm - Exterior corner radius: 8 mm - Flat top and flat bottom The housing must form a wide, stable tabletop base beneath a 284 mm-wide tablet cassette. Create a side-loading battery tunnel for a removable LiFePO4 battery measuring: - 152.4 mm long - 63.5 mm deep - 114.3 mm high - Weight: 0.73 kg Battery-tunnel requirements: - Battery inserts and removes through the left side. - Create a continuous open tunnel from the left exterior wall to an internal stop 220 mm from the left exterior edge. - Tunnel cross-section: 70 mm front-to-back × 120 mm high. - Center the tunnel front-to-back within the 95 mm housing depth. - Position the tunnel 4 mm above the exterior bottom surface. - Use a 3 mm radius on the left-side opening. - The battery must rest approximately centered left-to-right when fully inserted against the stop. - Provide at least 2 mm clearance around the battery. - Keep all tunnel surfaces straight and smooth for a future sliding battery sled. - Do not create undercuts that would prevent the battery from sliding horizontally out of the left side. Make the remaining right-side interior space a hollow electronics compartment separated from the battery tunnel by a 4 mm structural divider. Keep the electronics compartment enclosed for now. The bottom must be broad and completely flat so the entire scanner can stand upright and balanced on a table. Add editable parameters for: - Base Width: 284 mm - Base Depth: 95 mm - Base Height: 128 mm - Wall Thickness: 4 mm - Battery Length: 152.4 mm - Battery Depth: 63.5 mm - Battery Height: 114.3 mm - Battery Tunnel Depth: 70 mm - Battery Tunnel Height: 120 mm - Battery Stop Position: 220 mm - Corner Radius: 8 mm Generate only the stationary base housing. Do not create the battery, sliding sled, door, latch, handles, tablet enclosure, Kinect mount, ventilation holes, electronics, rubber feet, or mounting holes yet.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.