Low-Profile Vape Organizer

Recreate the attached reference image as closely as possible. Do NOT create a thick, solid rectangular box or a large flat block. The organizer must have a low-profile, elongated horizontal shape with a thin base and raised sections only where needed, matching the original reference. - **Overall shape:** Long, narrow, low-profile organizer with a thin bottom plate, shallow front wall, and minimal material usage. Follow the reference image's stepped silhouette and section heights. - **Front row:** 11 mm diameter vertical blind holes for drip tips, evenly spaced along the front edge. - **Center:** Exactly 15 vertical blind holes, 24 mm diameter, arranged in a 3×5 grid for atomizers. - **Left:** 8 vertical blind holes, 20 mm diameter, arranged in a 2×4 grid for 18650 batteries. - **Right:** An open-top rectangular vape mod holder, wider and deeper than in the reference, with raised side and back walls but no excessive surrounding material. - Keep each section compact and functional. The battery and atomizer holders should form raised platforms only as needed, while the front drip tip holes remain in a low front strip. - Match the original proportions, spacing, and stepped profile. Use rounded outer corners, flat bottoms, and clean 3D-printable geometry. The final result should look like a purpose-built desktop vape organizer, not a solid brick with holes. Prioritize the reference image's silhouette and proportions over a generic rectangular design.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.