Low-profile Electronics and Reef-lighting Enclosure Box

Design a precise, parametric low-profile electronics and reef-lighting enclosure box with outer dimensions of 180mm length, 75mm width, and 35mm total height, featuring a 2.5mm wall thickness. Divide the internal space into two distinct compartments using a 2mm thick vertical internal partition wall located 105mm from the left end: 1. LED Compartment (Left Side, 105mm x 75mm): - Bottom Face: Cut out a central rectangular opening measuring 95mm x 65mm for light pass-through. Add a 2mm x 2mm internal perimeter ledge/recess along the inside bottom border to hold a 105mm x 75mm x 2mm sliding glass splash shield. - Top Face: Feature a centered 60mm circular cutout with 50mm x 50mm square M3 mounting screw hole patterns for a 6060 fan. 2. Controller Compartment (Right Side, 70mm x 75mm): - Bottom Face: Completely solid plastic floor. Include 4 cylindrical M3 screw standoffs (outer diameter 6mm, inner hole 3mm, height 5mm) arranged in a rectangle matching the mounting corners of a 70mm x 75mm circuit board. - Top Face: Feature a centered 60mm circular cutout with 50mm x 50mm square M3 mounting screw hole patterns for a second 6060 fan. 3. Back Side Panel: - Include a central 8mm circular hole for a screw-in DC power socket, flanked on both sides by a row of 4mm x 15mm vertical ventilation slots. 4. Internal Partition: - Include a 6mm x 6mm rectangular wire passthrough notch at the bottom center of the internal partition wall.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.