L-Shaped Mounting Bracket

Create a one-piece L-shaped mounting bracket in millimetres. Overall width 80 mm. Horizontal base: 80 mm wide, 50 mm deep, 6 mm thick. Vertical flange: 80 mm wide, 40 mm high, 6 mm thick, joined along the rear edge of the base at 90 degrees. Add two 6.5 mm diameter through-holes in the horizontal base, with hole centres 20 mm from the left and right side edges and 25 mm forward from the inside face of the vertical flange. Add two 6.5 mm diameter through-holes in the vertical flange, with centres 20 mm from the left and right side edges and 20 mm above the top face of the base. Add a 4 mm internal fillet along the full inside bend. Add 2 mm fillets to all external free edges. Keep all dimensions editable as parameters.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.