Gripper Jaw

Start Part & Sketch:Open a new Standard (mm).ipt file.Click Start 2D Sketch $\rightarrow$ select the XY Plane.Draw the L-Shaped Arm:Use the Line tool to draw an L-bracket/hook profile:Lower horizontal arm: 30 mm long × 8 mm thick.Vertical clamp face: 25 mm tall × 8 mm thick.Add a circular boss at the bottom-left corner for the hinge:Outer rounded contour: Radius 6 mm.Center hole: Diameter 3 mm (this matches the pivot pin hole on the base).Extrude:Click Finish Sketch $\rightarrow$ Extrude $\rightarrow$ Distance: 10 mm $\rightarrow$ Click OK.Add Push/Pull Linkage Hole (Actuator Connection):Start a 2D sketch on the side face of the lower arm.Place a circle: Diameter 3 mm, located about 12 mm away from the main pivot hole along the arm.Click Finish Sketch $\rightarrow$ Extrude (Cut) through-all.Add Grip Pad Recess (Inner Jaw Face):Start a sketch on the flat clamping face of the vertical tip.Draw a rectangle: 6 mm × 15 mm.Click Finish Sketch $\rightarrow$ Extrude (Cut) to a depth of 1 mm.Verification:Ensure the part resembles a rigid finger with two through-holes (one for pivoting at the base, one for driving) and a recessed pad on the grasping face.Save: Save as Gripper_Jaw.ipt.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.