Plates and panels
Fluted Barrel Planter
- Bounding box
- 50.4 × 7.8 × 120 mm
- Engine
- 3D Printing B-rep
- Parameters
- 12
- Published
- November 7, 2026
Download
Free to download and use. See the terms.
The prompt
Round flower pot, barrel shaped, with fine vertical fluted ribs all around the outer surface. Overall height 120 mm. Maximum outer diameter 140 mm at mid-height (60 mm from the bottom). Base outer diameter 112 mm, top opening outer diameter 126 mm, smooth curved profile between them. 64 evenly spaced vertical ribs, each rounded (semicircular), about 5 mm wide and 1.2 mm deep, running the full height of the pot with narrow rounded grooves between them. Wall thickness 2 mm measured at the bottom of the grooves, bottom plate thickness 3 mm. Open top with a plain smooth rim, smooth inside surface. 5 drain holes of 5 mm diameter in the bottom: one in the center and four evenly spaced on a 40 mm circle. Flat base. Designed for FDM 3D printing, no overhang steeper than 45 degrees, no supports needed.
Parameters
| Name | Value | Range |
|---|---|---|
| Overall height | 120 mm | 40 – 300 |
| Widest outer diameter | 140 mm | 50 – 320 |
| Outer diameter at base | 112 mm | 30 – 300 |
| Outer diameter at rim | 126 mm | 30 – 300 |
| Height of widest point | 60 mm | 10 – 250 |
| Wall thickness at groove bottom | 2 mm | 1.2 – 6 |
| Base plate thickness | 3 mm | 1.5 – 12 |
| Number of vertical ribs | 64 mm | 8 – 128 |
| Rib width at widest point | 5 mm | 2 – 14 |
| Rib height above groove surface | 1.2 mm | 0.4 – 4 |
| Drain hole diameter | 5 mm | 2 – 12 |
| Circle diameter of the 4 outer drain holes | 40 mm | 0 – 120 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Conveyor Belt Assembly
You can create a CAD model of a conveyor belt with a canvas for furniture weighing 350 kg with sheet metal shoulders and height 850 length 6000 and width canvas 1100
3-in-1 Adaptive Jack Head
Create a highly detailed professional mechanical engineering CAD drawing sheet titled: “3-IN-1 ADAPTIVE JACK HEAD – LINE DIAGRAM & DIMENSIONS” Subtitle: “ALL DIMENSIONS ARE IN mm”
Adjustable Bracket (Laser Cut)
Give a good laser cutting pattern in 1.6mm thickness sheet
Micro‑Needle Array with Counter‑Bored Port
A single-panel image, presented in two separate but similar side-by-side isometric views on a light blue-grey background, of a precise micro-fluidic device component. The component
Exploded Axonometric Section - Excavation, Raft Foundation and Retaining Wall
generami un esploso assonometrico a 30 gradi, in cui mi fai vedere il terreno, scavo a platea con casseri a perdere, plinti, pilastro e tutti gli altri componenti
Two-Deck Sumobot Chassis with Armour and Scoop
make the first plate and second plate the same, just flat. On the bottom make cutouts to where the wheel is supposed to go. attaching to the first base plate, should be a ledge tha