Flipper-Gehäuse: Unterteil + Deckel (exploded)

# TextoCAD Prompt — Flipper-Gehäuse ## HINWEIS TextoCAD arbeitet auf Englisch am zuverlässigsten. Prompt unten reinkopieren. Danach mit den Slidern die [PRÜFEN]-Maße korrigieren, sobald du die realen Bauteile vermessen hast. ## PROMPT (Unterteil / Wanne) Design a rectangular enclosure box, outer dimensions 83 mm long x 63 mm wide x 30 mm tall, with 2.5 mm wall thickness and a 2 mm thick floor, open at the top. Round the four vertical outer edges with a 3 mm radius. Inside the floor, add four cylindrical mounting standoffs 6 mm in diameter and 4 mm tall, each with a 2.3 mm diameter hole through the center, arranged in a rectangle with 58 mm spacing along the length and 23 mm spacing along the width, centered in the box. On one short end wall, cut a rectangular opening 18 mm wide x 8 mm tall for a USB connector, positioned 3 mm above the floor. On one long side wall near the top, cut a 4 mm diameter circular hole for an antenna. ## PROMPT (Deckel — separat generieren) Design a rectangular lid 83 mm long x 63 mm wide x 2.5 mm thick, with the four outer edges rounded at 3 mm radius. Cut a square window 40 mm x 40 mm centered in the lid. On the underside, add a rectangular lip 77.5 mm x 57.5 mm outer, 3 mm tall, with 2.5 mm wall thickness, to snap-fit into the enclosure below. ## MASSE ZUM NACHTRAGEN (aktuell Standardwerte) | Maß | Wert | Status | |---|---|---| | Gehäuse aussen | 83 x 63 x 30 mm | abgeleitet | | Pi-Lochraster | 58 x 23 mm | FIX | | Displayfenster | 40 x 40 mm | PRÜFEN (Oxocard) | | USB-Ausschnitt | 18 x 8 mm | PRÜFEN | | Antennenloch | Ø4 mm | Standard | ## EXPORT STL (fürs Slicen) oder STEP (falls du später in echtem CAD weiterbaust) → OrcaSlicer → Ender 3 V3 KE. PETG empfohlen wegen Snap-Fit.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.