Flat-Front Reservoir

Modify the existing reservoir while preserving all current dimensions and internal volumes. Keep unchanged: - overall size: 140 × 120 × 150 mm; - wall thickness: 5 mm; - lower chamber outer size: 115 mm wide × 28 mm deep; - lower chamber height: 100 mm; - upper opening: approximately 130 × 110 mm; - bottom drain hole: 12 mm diameter; - two slots: 103 × 3.8 mm; - slot centers at Z = 119 mm and Z = 135 mm; - slot center-to-center spacing: 16 mm. Important interface change: - The wall containing the two belt slots must be perfectly flat, vertical and planar. - This interface wall must not taper. - It must provide a continuous flat external contact surface for mounting directly against another flat vertical wall. - Keep both slots on this flat interface wall. - The opposite wall and lateral walls may remain tapered as needed to preserve the current reservoir volume and geometry. Do not create rollers, shafts, bearings, belt, motor, brackets, lid, valve or scraper. Generate one hollow solid reservoir body only.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.