Fixture Base with Retaining Wall and Guide Rails

Create a single watertight mechanical part. Overall dimensions: Create a rectangular base plate measuring 160 mm long, 100 mm wide and 4 mm thick. Front retaining stop: Along the entire front edge create a rectangular retaining wall. The wall shall be 3 mm thick and extend 3 mm above the top surface of the base plate. Inclined support: Immediately behind the retaining wall create a support surface inclined upward by exactly 10 degrees. The inclined section shall be 30 mm long. After the inclined section continue with one flat horizontal support surface for the remainder of the base plate. Guide rails: Create two identical rectangular guide rails. Position one rail on the left side and one rail on the right side. Each rail shall be: - Width: 5 mm - Height: 4 mm - Length: extend continuously from the end of the inclined support surface to the rear edge of the base plate. The rails run parallel to the long edges. Position each rail exactly 10 mm inwards from the corresponding outer side edge. Mounting holes: Create four vertical through holes. Hole diameter: 4.5 mm. Locate one hole near each corner. The center of every hole shall be exactly 10 mm from both adjacent outer edges. Manufacturing requirements: - Create exactly one solid body. - Ensure the model is watertight. - Use only sharp edges. - Do not add chamfers. - Do not add fillets. - Do not add text. - Do not add logos. - Do not add decorative features. - Keep all geometry simple and dimensionally accurate. - The complete model must be printable on an FDM printer without support.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.