Five-Nozzle Depositing Head Mounting Body

Create a compact rectangular mounting body for a five-nozzle depositing head. MAIN BODY Create a rectangular solid: * Width: 100 mm * Height: 70 mm * Depth: 25 mm The front face is 100 mm wide by 70 mm high. NOZZLE HOLES Create five cylindrical through-holes passing from the front face through the rear face. The holes are arranged horizontally across the centre of the front face. Hole centres: * N1 at X = -36 mm * N2 at X = -18 mm * N3 at X = 0 mm * N4 at X = +18 mm * N5 at X = +36 mm All five holes have: * Diameter: 6 mm * Identical diameter * Parallel axes * Axis perpendicular to the front face The distance between adjacent hole centres is exactly 18 mm. The nozzle-hole row is centred vertically on the body. The five holes therefore occupy a total centre-to-centre width of 72 mm. MOUNTING HOLES Create four additional cylindrical through-holes for mounting the body. Hole diameter: 5 mm. Position them symmetrically near the four corners of the body. Use these approximate centre positions on the front face: * Upper left: X = -42 mm, Y = +27 mm * Upper right: X = +42 mm, Y = +27 mm * Lower left: X = -42 mm, Y = -27 mm * Lower right: X = +42 mm, Y = -27 mm All four mounting holes pass completely through the 25 mm body depth. GENERAL GEOMETRY The result should be one rectangular solid with: * 5 nozzle through-holes * 4 mounting through-holes Keep the exterior surfaces flat. Use sharp 90-degree external edges. Do not add fillets or chamfers. Do not add decorative geometry. Do not add internal cavities. Do not add tube channels yet. Do not add fan mounts yet. Do not add heater mounts yet. Do not add any food-contact passages. This is the basic structural carrier for the Nourish depositing head. The five nozzle holes are the most important feature. Maintain exactly 18 mm spacing between the five nozzle-hole centres.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.