Elliptical Base with Mount, LED Channel, NFC Pocket

Create an elliptical base with these starting dimensions: Width: 140 mm Depth: 105 mm Overall height: 42 mm Bottom surface: completely flat Outer edges: rounded with approximately 4 mm fillets Minimum wall thickness: 3 mm The dimensions must remain editable as parametric variables. Sculpture mounting area Create a flat mounting surface centered on the top of the base. Mounting area diameter: approximately 55 mm Keep this area solid and structurally reinforced Do not create the sculpture itself Allow the mounting-area diameter to be changed parametrically LED light channel Create an elliptical recessed channel around the upper perimeter of the base. The channel should follow the overall elliptical shape of the base and form a continuous illuminated ring around the sculpture mounting area. Starting dimensions: Channel width: 5 mm Channel depth: 3 mm Distance from outside edge: approximately 7 mm Create an internal cable passage from the LED channel into the electronics compartment. The LED channel dimensions must be editable. NFC compartment Create a circular recessed pocket for an NFC tag near the front upper section of the base. NFC pocket dimensions: Diameter: 30 mm Depth: 2 mm Position the NFC tag horizontally and close to the exterior surface. Leave approximately 1–1.5 mm of plastic between the NFC tag and the external surface to improve smartphone NFC detection. Above the NFC location, engrave a small standardized NFC/contactless symbol into the exterior surface to show the user where to place their phone. The NFC symbol should be approximately 10–15 mm wide and shallowly engraved. Front personalization Create a centered personalization area on the front face. Engrave the following example text: LUNA Directly underneath, engrave: 2012 – 2026 Use two separate editable text parameters. The name should be larger than the dates. Recommended starting values: Name text height: 10 mm Date text height: 5 mm Engraving depth: 0.8–1 mm Keep the text horizontally centered on the front face.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.