Electronics Enclosure Box

Create a rectangular electronics enclosure box with external dimensions 140 mm wide, 60 mm deep, and 80 mm tall, with 2 mm wall thickness and rounded corners. On the front face (140 mm wide x 80 mm tall), add two through cutouts: (1) a display cutout 45 mm x 59 mm, horizontally centered, top edge 6 mm from the top edge of the box, for a 2.8 inch ILI9341 LCD; (2) a fingerprint sensor window cutout 14 mm x 18 mm, horizontally centered, located 60 mm below the top edge of the box. Inside the box, add mounting bosses for an ESP32 development board and a 56 x 20 x 21.5 mm FPM10A fingerprint module behind its window. Add a round 6 mm hole on the left side face for a USB Type-C power connector. On the right side face, add two through mounting holes of 4 mm diameter, positioned 15 mm from the front edge and 15 mm from the rear edge, vertically centered at 40 mm height, for wall mounting. On the left side face, add two matching through mounting holes of 4 mm diameter at the same positions, so the box can be screwed to a wall from either side.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.