Dremel 565 Routing Template

// Dremel 565 Routing Template for Bambu Lab A1 // Creates a 5mm OD corner fillet, 2.5mm from the edge of a 100x100mm wood block. $fn = 120; // High resolution smooth curves // Dimensions based on math calculations wood_size = 100; // 10cm wood piece groove_offset = 2.5; // 2.5mm from the edge shroud_radius = 30; // Dremel 565 shroud radius // Calculated internal cutout dimensions inner_size = 155; // 15.5cm total inner width inner_radius = 32.5; // 32.5mm inner corner radius frame_thickness = 15; // Sturdy 15mm wall for clamping template_height = 8; // 8mm height to guide the Dremel shroud outer_size = inner_size + (frame_thickness * 2); difference() { // Outer Frame Base linear_extrude(height = template_height) { minkowski() { square([outer_size - (inner_radius * 2), outer_size - (inner_radius * 2)], center = true); circle(r = inner_radius + frame_thickness); } } // Inner Cutout Guide (Where the Dremel travels) translate([0, 0, -1]) // Slight offset to ensure a clean cutout through the model linear_extrude(height = template_height + 2) { minkowski() { square([inner_size - (inner_radius * 2), inner_size - (inner_radius * 2)], center = true); circle(r = inner_radius); } } }

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.