DJI Mic Mini Slide-in Mount Sleeve

Generate a detailed 3D CAD model of a functional slide-in mount/sleeve for the DJI Mic Mini transmitter, optimized for 3D printing. The model must be a single solid block with a precise interior cavity and rounded exterior corners.Overall Exterior Dimensions:Total Width (X-axis): 32.0 mmTotal Depth/Length (Y-axis): 29.5 mmTotal Height (Z-axis): 22.0 mmExterior Style: Apply a 2.0 mm fillet (rounding) to all vertical exterior corners to ensure a smooth finish.Interior Cavity Configuration (Front-to-Back Sliding Design):The front face must be completely open to act as a sliding entrance.The back face must be a solid, closed wall acting as a hard stop (Tope Fijo).Inside, there must be a horizontal dividing tab (Pestaña de agarre) with a thickness of 1.5 mm. This tab splits the cavity into a Superior and an Inferior compartment.Compartment Dimensions & Tolerances:Superior Compartment (For Microphone Body): Located above the dividing tab. Dimensions must be 13.5 mm in height (Z) and wide enough to accommodate the microphone body with a 0.3 mm clearance on each side.Inferior Compartment (For Clip Clearance): Located below the dividing tab. Dimensions must be 5.0 mm in height (Z) to clear the plastic clip.Critical Alignment Details (The Sacado):The internal 1.5 mm dividing tab must NOT start at the front entrance. It must be recessed (retranqueada) by exactly 5.0 mm from the front opening edge. This 5 mm gap (sacado) allows the microphone body to slide completely inside and sit perfectly flush (enrasado) with the front margin, while the integrated clip advances to bite the recessed tab.Add a 1.0 mm chamfer at the entrance edges of both compartments to facilitate smooth sliding.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.