Dashboard Cup Holder Cartridge

Create a parametric, single-body mounting cartridge for a car dashboard cup holder replacement: 1. Chassis Sleeve: - Centered rectangular box: 118 mm wide (X) x 27.5 mm high (Y) x 55 mm long (-Z). - Shell hollow from the rear (-Z face) with a uniform 3 mm wall thickness (interior cavity: 112 mm x 21.5 mm x 52 mm deep). 2. Front Faceplate Flange: - At Z = 0, create a centered front faceplate: 124 mm wide (X) x 30 mm high (Y) x 3 mm thick (+Z). - Add 3.5 mm fillets to the 4 outer corners of the faceplate. - Merge the faceplate with the front of the sleeve body. 3. Side Mounting Tabs: - Add two lateral mounting tabs on the left and right exterior side walls at Z = -40 mm, flush with the top surface. - Tab size: 10 mm wide (X) x 16 mm deep (Z) x 4 mm thick (Y). - Center-to-center hole spacing: 134 mm (X = +67 mm and X = -67 mm). - Cut a 5.2 mm diameter through-hole vertically through each tab. 4. MagSafe Front Pocket: - On the front face (Z = +3 mm), cut a centered circular pocket: diameter 56.2 mm, depth 5.8 mm. - At the center of this circular pocket, cut a concentric 20 mm through-hole extending through into the hollow cavity. - At the 6 o'clock position of the pocket, cut a rectangular cable pass-through slot: 4.5 mm wide (X) x 3.5 mm deep (Y) connecting the pocket to the hollow cavity.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.