Cube PC Case with Top Screen and Controls

Okay, I'm working on this cube. So on top—the front upper part—there should be a small area, sort of like a triangle, I'd say. It's not the usual thin piece of material, but the edge should be slightly beveled, as they say. I don't know exactly how many degrees—just enough so that it's beveled. On top of that, there should be a 3. 2-inch area where a screen fits. On the right side, everything should be arranged so you can operate it—up, down, left, right—and confirm. At the bottom, there can be two more buttons to the left, stacked one above the other, making three buttons in total, each with a small LED. From a top-down view, the power button should be in the top-left corner. From the front, looking back, then back to the front again—at the top, you can install the motherboard; on the right, you can installed on the right; you can install the motherboard on the left as well, but there should be enough slots so that everything can be set up the way you want. On the left side, the motherboard really should be installed there—so please, please, please, please, please, please remove these two holes; they don’t make any sense. Cable management will also be easier for you with a clear layout—just use small rubber grommets for those two holes, as usual, please. Translated with DeepL.com (free version)

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.