Component Organizer Box with Hinged Lid

Create a rectangular box enclosure, 220 mm long, 140 mm wide, 55 mm tall, with 2 mm wall thickness and 3 mm rounded edges. On top, in the front half (115 mm of the length), cut a 7 by 4 grid of rectangular pockets, 28 pockets total, each about 26 mm by 18 mm and 12 mm deep, with small gaps between them. In the rear half (105 mm of the length), leave an open compartment for electronics. Add a flat lid on top, 3 mm thick, hinged along one long edge, with a rectangular window cutout in the middle, about 180 mm by 100 mm.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.