Enclosures and housings
Component Mounting Plate with Snap-Fit Enclosures
- Bounding box
- 180.0 × 160.0 × 19.0 mm
- Engine
- Precision B-rep
- Parameters
- 20
- Published
- September 6, 2026
Download
Free to download and use. See the terms.
The prompt
Create a flat rectangular base plate 180mm along the X-axis, 160mm along the Y-axis, and 3mm thick. On the top face, generate three separate non-overlapping enclosures. Each enclosure must have 2mm thick walls and a 1mm inward-facing lip along the top inside edge: Breadboard enclosure: Inner dimensions 166mm (X) by 56mm (Y) with 8mm tall walls. Position this centered along the back Y-edge of the plate. Battery enclosure: Inner dimensions 60mm (X) by 90mm (Y) with 15mm tall walls. Position this flush in the front-left corner of the plate. Power bank enclosure: Inner dimensions 65mm (X) by 100mm (Y) with 15mm tall walls. Position this flush in the front-right corner of the plate. Cut exactly four 3.2mm diameter circular screw holes straight through the 3mm base plate. Place one hole exactly 5mm inward from each of the four extreme corners of the plate. Finally, cut two 20mm by 10mm rectangular slots straight through the center of the base plate between the enclosures to act as cable management routing holes.
Parameters
| Name | Value | Range |
|---|---|---|
| Plate Length (X) | 180 mm | 100 – 300 |
| Plate Width (Y) | 160 mm | 80 – 250 |
| Plate Thickness | 3 mm | 1 – 10 |
| Wall Thickness | 2 mm | 1 – 5 |
| Lip Depth (inward) | 1 mm | 0.5 – 3 |
| Lip Height | 1 mm | 0.5 – 3 |
| Breadboard Inner Length (X) | 166 mm | 100 – 175 |
| Breadboard Inner Width (Y) | 56 mm | 30 – 100 |
| Breadboard Wall Height | 8 mm | 5 – 20 |
| Battery Inner Length (X) | 60 mm | 30 – 100 |
| Battery Inner Width (Y) | 90 mm | 40 – 120 |
| Battery Wall Height | 15 mm | 5 – 30 |
| Power Bank Inner Length (X) | 65 mm | 30 – 100 |
| Power Bank Inner Width (Y) | 100 mm | 40 – 130 |
| Power Bank Wall Height | 15 mm | 5 – 30 |
| Screw Hole Diameter | 3.2 mm | 2 – 6 |
| Corner Offset | 5 mm | 3 – 15 |
| Slot Length (X) | 20 mm | 5 – 40 |
| Slot Width (Y) | 10 mm | 3 – 30 |
| Slot Separation | 30 mm | 15 – 60 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Cylindrical Stainless Steel Basket with Folding Handles
Design a cylindrical 304 stainless steel basket with an outer diameter of 200 mm and height of 250 mm. The basket has solid side walls with no perforations. The bottom plate contai
Spur Gearbox
design gearbox
Trumpet Lyre Mount Main Body
A single 3D mechanical CAD part for a trumpet music lyre mount (Main Body with Paddle). Geometry details: 1. A 18mm-wide semi-cylindrical clamp arc for a 28mm diameter cylinder, w