Bollard Film Holder – 8″ Platform

Create a parametric 3D CAD assembly of a stainless steel bollard film holder system consisting of a main cylinder, a semi-circular platform, and three triangular support gussets. 1. MAIN BOLLARD: - Create a vertical cylinder with an Outer Diameter (OD) of 2.00 inches and a total length of 32.00 inches. - Establish the bottom end as Z = 0. 2. SEMI-CIRCULAR PLATFORM: - Create a flat, semi-circular plate with a thickness of 1/8 inch (0.125 inches). - The outer diameter (OD) extent must be exactly 8.00 inches (a 4.00-inch outer radius). - Cut a concentric semi-circular hole in the center with an inner diameter of 2.00 inches to sleeve perfectly around the vertical cylinder. - Orientation & Placement: Position this platform horizontally around the cylinder with the flat edge facing forward. Set the top surface of this platform at exactly Z = 19.00 inches. - Apply a 0.05-inch edge fillet (rounding) along the outer curved boundary of the semi-circle to eliminate sharp edges for ergonomic safety. 3. SUPPORT GUSSETS (QUANTITY: 3): - Create three identical right-triangular gusset plates with a thickness of 1/8 inch. - Each triangular gusset must have a vertical leg length of 3.00 inches and a horizontal leg length of 3.00 inches. - Position the top 3.00-inch horizontal leg flush against the underside of the platform (terminating at Z = 18.875 inches). - Space the three gussets radially around the semi-circle: - Place Gusset 1 (Right Edge) exactly at 0 degrees. - Place Gusset 2 (Center) exactly at the 90-degree midpoint. - Place Gusset 3 (Left Edge) exactly at 180 degrees. - Flush the 3-inch vertical leg of each triangle flat against the outer curvature of the 2-inch cylinder. 4. MATERIAL & MANUFACTURING METADATA: - Assign the material for all components as Grade 304 Stainless Steel with a Brushed (No. 4) finish. - Generate standard 1/8-inch continuous fillet welds at all joint intersections where the gussets meet the cylinder and the underside of the platform.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.