AWD Drivetrain Packaging Massing Model

Create a simplified dimensional massing model (blocky placeholder envelopes only, no detailed features) of an AWD drivetrain packaging layout, for CAD reference. Output as STL. Units: inches. Coordinate system: origin at the FRONT AXLE centerline, at ground level, on the vehicle centerline. X = longitudinal (positive toward rear). Y = vertical (positive up). Z = lateral (positive toward passenger/right side). FIXED REFERENCE (accurate): - Ground plane at Y = 0. - Front axle centerline: line along Z at X = 0, Y = 13. - Rear axle centerline: line along Z at X = 110.5, Y = 13. - Four wheels: cylinders 26 dia x 10 wide, centered at (0, 13, +30.5), (0, 13, -30.5), (110.5, 13, +30.5), (110.5, 13, -30.5). COMPONENT ENVELOPES (placeholders; label each; positions adjustable): - Engine block: box 29L x 25W x 28H, crank centerline at Y = 11, front face at X = 6. - Transmission (10L80): box 24L x 18W x 18H, on crank axis directly behind the engine. - Transfer case (NV149): cylinder 13L x 9 dia, behind the transmission, offset toward driver side. - Front differential: box 10L x 12W x 8H, centered at X = 0, offset toward passenger side (Z = +4), center height Y = 7. - Oil pan: box 14L x 12W x 6H, hanging below the engine front, bottom near Y = 4. - Front CV axles: two rods from front-diff outputs to front wheel centers. - Front driveshaft: rod from transfer-case front output to front diff. - Rear driveshaft: rod from transfer-case rear output to rear axle. Keep all bodies as separate labeled solids.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.