Ampio M-REL-2s Relay Module

Create an accurate 3D CAD model of an Ampio M-REL-2s electronic relay module based on the provided technical drawing. Main dimensions (in millimeters): Overall height including terminal blocks: 110 mm. Main housing height: 90 mm. Main housing width: 35 mm. Maximum housing depth: 59 mm. Side profile includes a 33.5 mm deep main section and a 15 mm stepped section. Main housing: Create a solid rectangular electronic module housing, 35 mm wide and 90 mm high. Reproduce the stepped side profile shown in the technical drawing. The rear section includes a recessed vertical channel for DIN rail mounting. The opposite side has a stepped contour with a slightly curved, outward-projecting central surface. Use flat front surfaces, sharp edges, and a clean industrial design. Add horizontal separation lines near the upper and lower parts of the front panel. Upper screw terminal block: Located at the top center of the housing. Protrudes 10 mm above the main housing. Approximately 15 mm wide. Contains three identical circular screw heads in one horizontal row. Each screw head is approximately 4 mm in diameter. Space the screw centers approximately 5 mm apart. Each screw has a diagonal straight slot oriented at 45 degrees. Lower screw terminal block: Located at the bottom center of the housing. Protrudes 10 mm below the main housing. Approximately 20 mm wide. Contains four identical circular screw heads in one horizontal row. Use the same screw diameter, spacing, and diagonal slots as the upper terminal block. Front panel details: Add the Ampio logo near the upper part of the front panel. Add the model name "M-REL-2s". Include three small circular LED indicators labeled RELAY 1, RELAY 2, and CAN. Add the label "RELAY OUTPUTS" above the upper terminal connections. Add the label "CAN BUS" near the lower terminal block. Use a simple white or light gray plastic enclosure. Modeling requirements: Create a complete three-dimensional solid model, not a flat drawing. Preserve the exact overall dimensions of 35 × 59 × 110 mm. Keep the upper three-screw terminal and lower four-screw terminal centered. The overall housing and side profile must match the technical drawing. All dimensions are in millimeters. Prioritize accurate geometry, proportions, screw terminals, and housing shape over decorative text and logos. Do not add cables, wires, or external components.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.