2×2 Storage Organizer

Create a parametric storage organizer with a 2×2 grid of compartments. Each compartment should have internal dimensions of 80 mm × 80 mm and a height of 80 mm. Use 3 mm thick outer walls, 3 mm thick divider walls, and a 3 mm thick bottom. Overall outside dimensions should be approximately 169 mm × 169 mm. Add 10 mm radius fillets to the outside vertical corners. Include two large rounded U-shaped finger cutouts on each outside wall, centered on each compartment, approximately 40 mm wide by 30 mm tall. Add four 4 mm drain holes in the bottom of each compartment near the corners. Apply a recessed honeycomb texture about 1 mm deep to the exterior walls only, leaving a smooth border around the edges. Keep all interior walls smooth. The organizer should print upright without supports on an adx5 printer.

Parameters

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.