TikiTender V3 Catamaran

Rebuild the TikiTender V3 completely from scratch as a premium low-profile RC pool-service catamaran exterior concept. Overall dimensions: - 720 mm long - 420 mm wide - approximately 220 to 260 mm maximum overall height including the FPV camera - calm swimming-pool use - target operating displacement approximately 5.2 kg Design language: - premium consumer-product styling inspired by DJI and Bambu Lab - smooth continuous surfaces - consistent large fillets and rounded transitions - clean modular panel lines - hidden fasteners - professional injection-moulded appearance - no simple rectangular barge hulls - no large flat slab deck - no tall freestanding cylindrical cup holders - no exposed joiner plates - avoid primitive box-and-cylinder styling Hull geometry: - two slender catamaran hulls - approximately 105 to 115 mm wide per hull - hull centreline spacing approximately 300 to 315 mm - clearly open tunnel between hulls - rounded near-plumb wave-piercing-inspired bows - bows taper smoothly over the forward 160 to 190 mm - softened chines and generous reserve buoyancy above the waterline - sculpted sterns with one protected rear-facing thruster cassette per hull - thruster outlets must be clearly shown at the stern - normal design draft approximately 55 to 65 mm - bridge underside approximately 40 to 50 mm above the normal waterline Central architecture: - a one-piece structural electronics pod positioned at midships - pod approximately 235 to 245 mm wide and 220 to 240 mm long - the removable pod lid forms a large recessed snack tray - show a narrow continuous sealing reveal around the lid - the snack tray must be visually dominant and genuinely useful - pod should connect the hulls structurally without creating a full-width flat slab Drink holders: - four Australian 375 mL can positions - two per side near midships - integrated into the sculpted inner hull shoulders - shallow recessed wells rather than tall cylinders - rounded lips and premium detailing - keep all four cans close to the longitudinal centre of the boat Front equipment: - low centreline water cannon integrated into a removable forward wet-service module - protective sculpted housing around the cannon - short FPV camera pylon located behind or above the cannon - camera must have a clear forward view - camera is the only component extending significantly above the deck - use a strong sculpted pylon, not a thin pole Manufacturing architecture: - exterior must suggest three printable longitudinal sections per hull - conceal hull split lines beneath intentional shoulder bands or module boundaries - central pod and snack-tray lid must each fit inside a 256 x 256 x 256 mm Bambu P1S build volume - modules should look intentional rather than visibly assembled Generate a coherent industrial-design concept with a clear bow and stern. Show top, side, front and three-quarter views.

Parameters

This model was generated without adjustable parameters. Open it in the editor to add your own dimensions.

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.