3D preview of Sticker Roll Dispenser Stack
Loading the interactive model…
Interactive 3D model of Sticker Roll Dispenser Stack

Plates and panels

Sticker Roll Dispenser Stack

1 views
Bounding box
47 × 54.8 × 164.4 mm
Engine
3D Printing B-rep
Parameters
24
Published
November 18, 2026

Download

Free to download and use. See the terms.

The prompt

Step 7: Add 1 mm fillets on the inside corners where the plates meet the back wall and the front walls, but keep the front-wall knife edges sharp. Check that it prints lying on its closed side (X = 0 face down) without supports: overhangs no steeper than 45 degrees, only short bridges under 20 mm. Expected overall size: 56.2 x 32.2 x 179.8 mm.

Parameters

NameValueRange
Backing liner width40 mm10 – 120
Roll diameter45 mm20 – 120
Number of stacked cells3 mm1 – 8
Wall thickness2.4 mm1.2 – 6
Horizontal plate thickness2 mm1.2 – 6
Lid thickness allowance2 mm1.2 – 5
Liner exit slot height2.5 mm1 – 8
Thumb notch top width24 mm10 – 60
Thumb notch depth7 mm2 – 15
Header block height15.4 mm8 – 40
Cleat slot depth from back face4.4 mm2 – 10
Cleat slot height at its inner end13.4 mm4 – 35
Label recess width40 mm10 – 120
Label recess height9 mm4 – 30
Label recess depth0.6 mm0.2 – 2
Back-bottom wedge leg length7 mm3 – 20
Bottom groove size3 mm1 – 8
Lid stop block height4 mm2 – 15
Lid stop block length along depth8 mm3 – 30
Snap lip protrusion into channel0.3 mm0.1 – 1
Spool pin diameter7 mm3 – 20
Gap between pin tip and open side1.2 mm0 – 10
Pin tip chamfer0.6 mm0 – 2
Inside corner fillet radius1 mm0 – 3

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.