Plates and panels
Sticker Roll Dispenser Stack
- Bounding box
- 45 × 54.8 × 149 mm
- Engine
- 3D Printing B-rep
- Parameters
- 9
- Published
- November 18, 2026
Download
Free to download and use. See the terms.
The prompt
Step 2: Give every cell a front wall from Y = body_d - wall to body_d, across the full cell width. It starts on the plate below and stops exit_gap below the plate above, leaving a full-width slot where the backing paper comes out. Chamfer the whole top of each front wall at 45 degrees, sloping down toward the inside of the cell, so the top outer edge is a sharp knife edge with no rounding. This edge peels the stickers off. Then, centered on each cell's width, cut a trapezoid thumb notch down from the top of every front wall, through its thickness: notch_top_w = 24 wide at the top, notch_depth = 7 deep, 45-degree sides (10 wide at the bottom).
Parameters
| Name | Value | Range |
|---|---|---|
| Backing liner width | 40 mm | 10 – 120 |
| Roll diameter | 45 mm | 20 – 120 |
| Number of stacked cells | 3 mm | 1 – 8 |
| Wall thickness | 2.4 mm | 1.2 – 6 |
| Horizontal plate thickness | 2 mm | 1.2 – 6 |
| Lid thickness allowance | 2 mm | 1.2 – 5 |
| Liner exit slot height | 2.5 mm | 1 – 8 |
| Thumb notch top width | 24 mm | 10 – 60 |
| Thumb notch depth | 7 mm | 2 – 15 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Gabinete Gamer DeX com Suporte Interno para Hub USB-C
Atualize o projeto 3D existente sem mudar o restante do design. - Esconda o hub USB-C em um compartimento interno com tampa removível. - Crie um suporte para o hub entre duas pare
Conveyor Belt Assembly
You can create a CAD model of a conveyor belt with a canvas for furniture weighing 350 kg with sheet metal shoulders and height 850 length 6000 and width canvas 1100
Interdigital Electrode Pattern
### FIG. 2 — Top plan view of the interdigital electrode pattern *Suggested template: USPTO Line Art / Electronic Circuit* ``` FIG. 2: A top plan (bird's-eye) view of an interdigi
3-in-1 Adaptive Jack Head
Create a highly detailed professional mechanical engineering CAD drawing sheet titled: “3-IN-1 ADAPTIVE JACK HEAD – LINE DIAGRAM & DIMENSIONS” Subtitle: “ALL DIMENSIONS ARE IN mm”
FPV Drone Frame (Exploded)
I want a design of a FPV 5 inch carbon frame of a FPV drone racing. Inspied on switchback five 33 frame and similar to BCROW v7. 5mm arms and 2mm top and bottom plate. Make a desig
Adjustable Bracket (Laser Cut)
Give a good laser cutting pattern in 1.6mm thickness sheet
