Spiral Dune Desk Stand

Design an organic spiral desk stand that functions as both a pen holder and a tablet/phone stand, single continuous piece. Base diameter 90mm, total height 140mm, wall thickness 4mm throughout. The form should twist smoothly from base to top like a helix, rotating approximately 120 degrees total from bottom to top, creating a flowing spiral silhouette. The base starts as a wide, stable circular foot (90mm diameter, 15mm height) that gradually twists and tapers upward. At the top of the spiral (around 100-140mm height), the form should open into a smooth curved cradle/groove, angled at 65 degrees from vertical, wide enough to hold a tablet or phone (groove width 12mm, depth 15mm) — the tablet should rest securely leaning back into this curved support. Around the mid-height of the spiral (40-90mm), incorporate 4-6 asymmetrically placed circular holes (18mm diameter each) twisting around the surface, positioned to hold pens and pencils upright at slightly varied angles, following the natural twist of the form. Surface should be smooth and continuous with no sharp edges — apply large soft fillets (5-8mm) throughout. No flat faces; every transition should flow organically like a ribbon or dune. Base must have a flat, stable bottom for desk placement, with the widest point at the base for tipping resistance. Style: minimalist, sculptural, modern desk accessory, single-piece 3D-printable design, no supports needed if possible (self-supporting overhangs under 45 degrees)

Parameters

This model was generated without adjustable parameters. Open it in the editor to add your own dimensions.

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.