Open Plywood Attaché Case

Create a parametric wooden attaché-case enclosure in millimeters. Overall closed size 450 mm wide (X), 350 mm deep (Y), 120 mm high (Z). Plywood thickness 8 mm. Base outer height 80 mm, lid outer height 40 mm. Front is Y=0, rear is Y=350. Expose width, depth, closed height, plywood thickness, base height, and lid height as editable parameters. Base: flat bottom panel 450 by 350 by 8 mm. Walls sit on the bottom in a butt joint. Wall height 72 mm. Front and rear walls 450 by 8 by 72 mm. Side walls 8 by 334 by 72 mm. Clear cavity 434 by 334 by 72 mm. Empty interior, no organizers. Floor lining only, grey wood-grain sheet, 1 mm thick. Lid: matching 450 by 350 mm frame. Outer face 8 mm. Lid walls 32 mm high. Inner face darker reddish plywood. Three butt hinges on the rear edge. Lid opens to 105 degrees from the closed position. Two slender metal lid stays, one on each side, from the middle of the lid side wall to the middle of the base side wall. On the lid inner face, left of center, a screen pocket for a 10.1 inch HDMI display, 1024 by 600. Active area 222 by 125 mm. Module outline 235 by 145 mm. Cut the module outline, not the active area. Mounting depth 8 mm. Dark inactive screen placeholder in the opening. Immediately to the right of the screen, a 9 mm camera hole. Further right of the camera, a 40 mm fan opening with a simple round grille. Metal corner plates on the four corners of the lid. Front of the base: black carrying handle centered on the front wall, grip span 130 mm, standing off the wall. Two latch keepers on the front edge, 200 mm apart, centered. Four rubber feet under the bottom, 15 mm diameter, 5 mm thick, inset 20 mm from each corner. Separate bodies for panels, lining, handle, hinges, stays, latches, feet, screen, camera hole, and fan. Show a closed isometric and an open isometric at 105 degrees. Label the model Preliminary enclosure design.; then Revise the existing 450 x 350 x 120 mm plywood attaché case so it matches the built prototype. Keep the size: base height 80 mm, lid height 40 mm, plywood 8 mm. Closed: light plywood box, black plastic handle centered on the front face, two small metal latches on the right side edge, visible seam between lid and base. Open: lid rotated 105 degrees on the rear hinge. Inner lid is darker reddish plywood. A 10.1 inch dark screen sits left of center. A small camera hole is immediately to the right of the screen. A small round fan grille is further right, lower than the camera. Metal corner plates on the top corners of the lid. Two thin metal stays, one on each side, holding the lid open. Base is empty with a light grey wood-grain floor liner. Black handle remains on the front wall. One small metal latch plate on the front inner lip. Show the open configuration. Do not change overall size.

Parameters

This model was generated without adjustable parameters. Open it in the editor to add your own dimensions.

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.