Minimalist Book Stand

"Design a minimalist book stand for holding a single book or tablet upright at a reading angle, optimized for FDM 3D printing without supports. Overall footprint: approximately 150mm wide x 120mm deep x 100mm tall A flat base plate with a raised back panel angled at 60–65 degrees from horizontal to cradle the book A small lip or ledge (8–10mm tall) along the front bottom edge to stop the book from sliding off Wall/panel thickness: 4mm for strength without excess material Smooth, continuous curves at all edges and corners — no sharp 90-degree joints, rounded fillets (2–3mm radius) throughout for a clean minimal look No overhangs greater than 45 degrees, so it prints flat on the build plate with no supports needed Solid, flat bottom surface for good bed adhesion No decorative cutouts, no logos, no added texture — smooth uniform surfaces only Design should be a single printable piece (no assembly required)"

Parameters

This model was generated without adjustable parameters. Open it in the editor to add your own dimensions.

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.