Gears and transmission
Hammer Mill – 1 mm Charcoal Powder Version
- Bounding box
- 750.1 × 1372.1 × 1037.3 mm
- Engine
- Precision B-rep
- Parameters
- 23
- Published
- November 22, 2026
Download
Free to download and use. See the terms.
The prompt
Hammer mill updated to powderize raw charcoal lump to 1 mm: fine mesh screen with support grid, 6 hammer pins, tighter tip clearance, higher-speed pulley ratio
Parameters
| Name | Value | Range |
|---|---|---|
| Grinding chamber inner dia (tighter for fines) | 384 mm | 300 – 600 |
| Chamber length (between end plates) | 240 mm | 200 – 400 |
| Casing wall thickness | 8 mm | 4 – 16 |
| Feed opening length (along shaft) | 200 mm | 120 – 300 |
| Feed opening width | 220 mm | 120 – 300 |
| Hopper height | 280 mm | 150 – 450 |
| Main shaft dia | 60 mm | 40 – 80 |
| Rotor disc dia | 240 mm | 180 – 300 |
| Rotor disc thickness | 8 mm | 5 – 16 |
| Number of rotor discs | 5 | 3 – 7 |
| Hammer pin circle dia | 200 mm | 160 – 260 |
| Hammer pin dia | 16 mm | 10 – 24 |
| Number of hammer pins | 6 | 3 – 8 |
| Hammer length | 100 mm | 70 – 130 |
| Hammer width | 40 mm | 25 – 60 |
| Hammer thickness | 12 mm | 6 – 20 |
| Screen support grid hole dia | 20 mm | 10 – 30 |
| Screen support grid pitch | 28 mm | 24 – 50 |
| Fine mesh / sheet thickness | 1.5 mm | 1 – 3 |
| Mill pulley dia (smaller = faster) | 200 mm | 150 – 350 |
| Motor pulley dia | 250 mm | 120 – 300 |
| Motor centre distance (horizontal) | 900 mm | 700 – 1300 |
| Bolt dia (M12 default) | 12 mm | 8 – 20 |
Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.
More models
Browse the full gallery →Spur Gearbox
design gearbox
Involute Spur Gear with Keyway
Precision Involute Spur Gear with Hub and Keyway: Module (m) of 2.0 mm, 40 teeth (z), Pitch Circle Diameter (d) of 80.00 mm, 20° pressure angle (\alpha), 15.00 mm face width (b), a
Parametric Helical Gear
Create a parametric helical gear with the following specifications: 32 teeth, normal module of 3 mm, right-hand helix, total face width of 80 mm, and a central bore hole with a dia
Rod with Spur Gear
Metal rod diameter is 20 mm and length is 100 mm and right side attach a gear and their OD is 50 mm
Spur Gear (12 Teeth)
Built a gear with 12 teeth
Meat Grinder Middle Gear
This is the middle gear of the meat grinder: large wheel Ø68 (78 teeth, helical tooth to the right), spur gear Ø20 (8 teeth), hole Ø8, total height 32 mm.
