Display Base Rear Chassis

Display Base - Part 1: Rear Chassis • Overall Dimensions: • Length: 240mm. • Maximum Height: 50mm. • Maximum Depth Footprint: 35mm (consisting of a 20mm main body depth and 15mm protruding hinge blocks). • Base Floor: 5mm structural thickness. • Corner Rounding: 2mm radius applied to the outer XY corners. • Pencil Sockets: 18 cylindrical sockets measuring 9.7mm in diameter. The sockets span 212.5mm across the chassis, resulting in a 12.5mm center-to-center spacing. • Hinge Blocks: Two forward-facing blocks measuring 12mm in length, 15mm in depth, and 35mm in height. • Axle Through-Holes: 4.2mm diameter (2.1mm radius) extending 20mm deep, explicitly optimized for M4 bolts. These pivot points are positioned 5mm above the base floor on the Z-axis. • Mounting Hardware (Keyholes): Dual recessed wall-mounting keyholes centered at X = ±80mm and Z = 40mm. The primary entry holes are 8mm in diameter (4mm radius), dropping to a 4mm diameter (2mm radius) lock slot. • Velcro Channel: A horizontal recess across the rear face spanning 220mm in length. The profile is 20mm tall and cuts 2.5mm deep into the chassis. • Magnet Pockets: Two flush-mount circular pockets with a 6.3mm diameter (3.15mm radius) and a depth of 2.2mm. These are located exactly at X = ±100mm and Z = 30mm.

Parameters

This model was generated without adjustable parameters. Open it in the editor to add your own dimensions.

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.