Classic Tapered Teacup

Medium: revolve/loft profile + swept handle) Body: classic tapered cup, revolved profile Top outer diameter: 50 mm Base outer diameter: 30 mm Height: 65 mm Wall thickness: 3 mm (sturdy for FDM, no leaks through layer lines) Floor thickness: 4 mm Capacity: this geometry gives roughly ~230–250 ml before the rim Handle: swept oval-cross-section loop on the side, sized for 1 adult fingers Rim: slightly rounded/filleted lip, no sharp edge at mouth Base: flat foot for bed contact, small fillet at the body/base junction for print strength Assumptions I'm flagging Dimensions above (no real "standard teacup" spec exists — this is a reasonable size, adjust if you want bigger/smaller) Single-wall vessel (not double-wall insulated) — say if you want an insulated double-wall version instead Printed as one piece, vertical on the build plate, handle facing out (may need supports for handle overhang — I'll check with validate_for_printing)

Parameters

This model was generated without adjustable parameters. Open it in the editor to add your own dimensions.

Every value above is a live dimension. Open a model like this in the editor and each one becomes a slider you can drag before exporting.